User Manual LOCC-Box, LOCC-Pads
LOCC-Box-Net_1.61_HB_EN
15
3 LOCC-Pads (Software)
2)
3.1 Introduction
This section describes the installation and the functionality of the LOCC-Pads software. It also
describes the connection between LOCC-Pads (716410) and the Gateway (716459). The software
and all components are suitable to the LOCC-Box-Net modules. The software is compatible with
following operating systems:
§
Windows 2000
1)
§
Windows XP
1)
, 32 Bit
§
Windows Vista
1)
, 32 Bit
§
Windows 7
1)
, 32 Bit, 64Bit
The software is designed to parameterize, to analyze and to diagnose the LOCC-Box-Net and all
connecting loads. Connect the module via the USB interface to the computer, see chapter 3.3Fehler!
Verweisquelle konnte nicht gefunden werden.. For the communication between LOCC-Box-Net
and LOCC-Pads a Gateway is required.
Connect the Gateway after installing the software LOCC-Pads, otherwise an
installation of the device driver is not possible. The LOCC-Pads software is also
needed for the communication via RS232 and CANopen in order to set the
required parameters such as parity or baud rate. You can find detailed
information in chapter 3.4.3.
3.2 Installation
The Software package LOCC-Pads is needed for installation. The software can be downloaded free of
charge on the Lütze website:
www.luetze.de - Deutschland - Downloads - Eplan/Macros/Software
To install the software proceed as follows:
1. Download the file LOCC-Pads_x.x.x.x.zip and save it in any
directory. The directory can be deleted after the installation.
2. Extract the Zip-Files in the same directory.
3. Start the installation by double clicking on the file
LOCC-Pads_setup_xxxx.exe. Choose a setup language
(German / English). Confirm by clicking OK.
4. Windows
1)
starts the setup assistant. The
Assistant guides through the installation.
Follow the instructions and confirm with Next
to continue or Cancel to abort.
