19 |
P a g e
5.2 Associating LaunchPort Sleeve Buttons to a Grafik Eye QS
In order to program the LaunchPort Sleeve Buttons to the Grafik Eye QS, the Sleeve Buttons
must be associated to the Grafik Eye QS, either as a Scene controller or a Zone controller. To
start, ensure that the wireless mode of the Grafik Eye QS is
Enabled
. On the Sleeve Buttons,
hold down the top and bottom buttons of the column for 3 seconds. The LCD display of the
Grafik Eye QS will display Pico and ask if the type (zone or scene) of the Pico must change.
Press ok on the Grafik Eye QS.
Choose either Zone or Scene. Sleeve Buttons setup to control Scenes will activate the Scenes
of the Grafik Eye QS. For Sleeve Buttons oriented to the right of the iPad, the top button will
control Scene 1, the center button will control Scene 16, and the bottom button will control the
Off Scene.
If zone is chosen, the top button will send all assigned zones to 100%, bottom button send all
zones to 0%, and the middle button will send all zones to a defined preset value assigned by
setting each individual zones to a specific level using the local zone raise/lower buttons on the
Grafik Eye QS. Once the level is set, hold the 2
nd
and 4
th
buttons of the Sleeve Buttons to assign
the zone and set the preset level.
Pressing and holding the top and bottom Sleeve Buttons for 3 seconds will back the Sleeve
Buttons out of programming mode. Refer to the below illustrations for Grafik Eye QS button
legends and refer to
Appendix A
for more information on Sleeve Buttons and Pico mapping.
