© PROPERTY OF LUNDIX IT SWEDEN, ALL RIGHTS RESERVED – THIS DOCUMENT AND THE INFORMATION CONTAINED THEREIN ARE CONFIDENTIAL – THE DISCLOSURE OR OTHER COMMUNICATION, COPYING, REPRODUCTION
AND ANY USE WHATSOEVER IS FORBIDDEN WITHOUT THE WRITTEN AUTHORIZATION OF LUNDIX IT.
SPC Bridge KNX User Manual
Revision
1.0
Page
9 of 25
Reference
2020-111
3.2
Static IP Address
Default will SPC Bridge use DHCP to get an IP Address. To be sure that the SPC Bridge keeps the IP
address after a network/router restart you should assign the SPC Bridge a static IP Address. In the
System Administration GUI, go to
Network -> Interfaces
and:
1.
Select
LAN – Edit
.
2.
In
Interfaces – LAN
, select
Static address
in the
Protocol
option menu
3.
Click on
Switch Protocol
4.
In
Common Configuration – General Setup
fill in; IPv4 address, netmask, gateway and custom DNS
servers.
5.
In
DHCP Server – General Setup
; check the checkbox
Ignore interface
.
NOTE!
It is very important to
disable the DHCP server in the SPC Bridge to avoid conflict with your normal DHCP server.
6.
Click on
Save & Apply
.
7.
Redirect your browser to the new IP Address.
3.3
Time Setting
To set correct Timezone, go to
System -> System
and select
Timezone
in section
System Properties –
General Settings
.
The device is as default using NTP to synchronize time. This setting is in
System -> System
section
Time Synchronization
.
3.4
Change Administration Password
The default administration password for accessing the device is
dragino
. Of security reasons it is
highly recommended to change the password as soon as possible. Go to
System -> Administration
section
Device Password
to change the password. The same password is used in both Administration
Web GUI and for ssh access to the device.
NOTE!
The device has no RTC clock. During boot the device can have incorrect time. Some events
in the system log can therefore have incorrect timestamps.
Содержание SPC Bridge KNX
Страница 1: ...SPC Bridge KNX User Manual Revision 1 0...
