Lundix It SPC Bridge KNX, Руководство пользователя

Страница: 13 / 25

© PROPERTY OF LUNDIX IT SWEDEN, ALL RIGHTS RESERVED – THIS DOCUMENT AND THE INFORMATION CONTAINED THEREIN ARE CONFIDENTIAL – THE DISCLOSURE OR OTHER COMMUNICATION, COPYING, REPRODUCTION
AND ANY USE WHATSOEVER IS FORBIDDEN WITHOUT THE WRITTEN AUTHORIZATION OF LUNDIX IT.
SPC Bridge KNX User Manual
Revision 1.0
Page 13 of 25
Reference 2020-111
Element
Description
Programming Mode Click on Activate/Deactivate button to set/unset the interface programming mode. NOTE!
The interface has no physical programming mode button, so you need to use this feature
when ETS ask you to set the interface in programming mode. Normally this will only
happen when you do a full download.
Individual Address Individual KNX address of the interface. Can also be changed using ETS.
KNX Bus State Shows state of the KNX connection. Online or Offline.
Manufacturer KNX interface manufacturer
Serial Number KNX interface serial number
Protocol Version KNC interface protocol version
Configured Datapoints Number of datapoints that are linked to Group Addresses.
4.5 KNX Scenes
Interface -> KNX Scenes is used to configure KNX scene numbers that should be sent to the KNX-bus
when different SPC events occur. The scene number is sent to the KNX-bus via a common datapoint
(Scene Control Output), each time the assigned event occurs. The scene numbers are configured per
alarm area and can have values between 1 to 64 (Set 0 will disable the event).
An individual scene number can be assigned to following SPC events:

Area becomes unset

Area becomes partset A

Area becomes partset B

Area becomes fullset

Area reports an intrusion alarm

Area reports a fire alarm

Area reports a tamper alarm

Area reports a confirmed alarm

Area reports all alarms are restored