Lundix It SPC Bridge KNX, Руководство пользователя

Страница: 18 / 25

© PROPERTY OF LUNDIX IT SWEDEN, ALL RIGHTS RESERVED – THIS DOCUMENT AND THE INFORMATION CONTAINED THEREIN ARE CONFIDENTIAL – THE DISCLOSURE OR OTHER COMMUNICATION, COPYING, REPRODUCTION
AND ANY USE WHATSOEVER IS FORBIDDEN WITHOUT THE WRITTEN AUTHORIZATION OF LUNDIX IT.
SPC Bridge KNX User Manual
Revision 1.0
Page 18 of 25
Reference 2020-111
Datapoint
Address Name Values Datapoint Type Length Flags
11 Area unset
command ID of area to unset
The success/error of the command is
reported in “Area command reply status”.
DPT 5 1-byte C-W--
12 Area partset A
command ID of area to partset A
The success/error of the command is
reported in “Area command reply status”.
DPT 5 1-byte C-W--
13 Area partset B
command ID of area to partset B
The success/error of the command is
reported in “Area command reply status”.
DPT 5 1-byte
C-W--
14 Area fullset
command ID of area to fullset (immediately)
The success/error of the command is
reported in “Area command reply status”.
The fail to set reason is reported in “Area fail
to set reason”
DPT 5 1-byte
C-W--
15 Area delayed fullset
command ID of area to fullset when exit time has
expired
The success/error of the command is
reported in “Area command reply status”.
The fail to set reason is reported in “Area fail
to set reason” (after exit time has expired or
been canceled)
DPT 5 1-byte
C-W--
20 Area command
reply status 0 = Last area command succeeded,
1-255 = Area command failed error code.
Codes are listed in section 7.1 SPC Command
Error Codes.
DPT 5 1-byte CR-T-
Area ID = 1 to maximum number of areas (16).
5.2.4 SPC Zone Commands
Common for all SPC zones following Group Objects for commands will be available:
Datapoint
Address Name Values Datapoint Type Length Attributes
21 Zone inhibit
command ID of zone to inhibit
The success/error of the command is
reported in “Zone command reply status”.
DPT 5 1-byte C-W--
22 Zone deinhibit
command ID of zone to deinhibit
The success/error of the command is DPT 5 1-byte C-W--