Lumenis
®
Pulse
TM
50H / 100H Laser Systems
Treatment Screen Description
UM-20006520DE, Rev. A
Page 44
Treatment Screen Description
Once the laser self-test and warm-up have successfully completed, the
main
Treatment
screen displays on the control panel.
The elements of the
Treatment
screen are detailed as follows (the
numbered arrows in
figure 9
correlate to the numbered steps below):
1. Left Pedal Designation
– displays which footswitch pedal should be
used for the group of output parameters in the box beneath the
designator.
2. Right Pedal Designation
– displays which footswitch pedal should be
used for the group of output parameters in the box beneath the
designator.
3. Treatment Settings
for each pedal – each side of the screen defines
the
Energy
,
Frequency
and
Pulse width
settings for lasing when the
corresponding pedal is pressed. Press the
►
or
◄
selectors to reach
the desire settings; the derived power will be displayed
4. Pulse Width
– the user may set the laser emission mode to short or
long pulses. Toggle this button to select
Long
or
Short
pulses.
5. Aiming Beam
– the
Aim Beam
display shows the selected aiming
beam intensity: high, medium, low or off.
• At laser system turn on the aiming beam setting retains the intensity
setting from the last use of the laser system, or it will automatically
select the minimum setting it the aiming beam was turned off at the
last shut-down.
• Press the
Aim Beam
►
or
◄
selectors to set the aiming beam
intensity.
• To turn off the aiming beam, press the
◄
selector until no bars are
illuminated.
CAUTION:
If the aiming beam is turned off, ensure that the tip of the optical fiber and
the targeted surgical site are both under direct visualization.
