30
CHAPTER 4. SETUP MODE
ð
With the DIP Switch 2 in the ON position, setup mode may be entered through
the front panel, and any parameter may be viewed, but changes cannot be
made.
DISPLAY BACKLIGHT ‘Continuous On’:
The Model 3002 display backlight can be set to re-
main on continuously during operation. Follow the steps from
SETUP PROTECT
to access
the DIP switch but change DIP Switch 1 for display backlight selection. Setting DIP Switch 1
to the ON (forward) position will configure the display backlight to remain on during opera-
tion. Set DIP Switch 1 to the OFF (back) position, and the display will be backlit only when
light levels are low.
ð
Setting the display backlight for continuous-on operation can result in reduced
battery life. The backlight can be configured to always be off as well through the
device menu or Lumic 2.0 Calibration Software.
4.4 Setup Mode Operation
Once the Model 3002 is in Setup mode, setup page selection will be displayed on the LCD and
the Page number will be blinking indicating it as the selected item. The number of available
parameters per Setup Page will be displayed using the graph where the number of segments
indicates the number of parameters. Short press the MODE button to choose the Setup Page
you are interested in. Once the desired Setup Page is shown, short press the
α
−
β
button
to cycle down to the first parameter of that Setup Page. Further short presses on the MODE
button will cycle down through the parameters for that page. Extra-long-pressing the
α
−
β
button will go back up to the Setup Page. Extra-long pressing again will exit the Setup Mode.
Figure 4.1: Setup Page Selection Display (showing page 4-CAL)
To exit more quickly, press and hold the
α
−
β
button, no matter what parameter is shown,
will walk the user through all previous Setup Menu levels until the instrument returns to
normal operation.
When you get to a parameter that you want to change, use the MODE button to make the
change. If numbers are displayed on the parameter, the MODE button will increment the
numbers. Otherwise, the MODE button will cycle through the available settings. When you
have adjusted the parameter setting to your desired number or setting, extra-long press the
α
−
β
button. This will save the change and send you back up one screen to the page param-
Ludlum Measurements, Inc.
