16
CHAPTER 2. GETTING STARTED
• A long press, greater than 1/2 second but less than 2 seconds, will force the instrument
to emit one beep. Release the button after the beep to activate the second level of
operation.
• An extra-long press and release, greater than 2 seconds and after the second instru-
ment beep, will activate the highest level of operation. After the second beep, the but-
ton may be released.
By default, the majority of functions are assigned to short presses of the buttons.
2.5.1 ON/OFF Button:
Used to power the Model 3002 ON and OFF.
• Power On: Press for approximately one second and release.
• Power Off: Press and hold for approximately five seconds. The display will show a 3, 2,
1 countdown after the second beep. Releasing the ON/OFF button during shutdown
will return the device to the previous state of operation. At completion of the shutdown
count, the LCD will go blank (unless a USB cable is connected in which case the USB
icon will flash).
Short Press (press and release before one beep):
• During normal operation, it will acknowledge/silence alarms in any mode of opera-
tion.
• Change Log Location selected position (If data logging mode 2 is enabled).
• Will move selection position in the device menu.
Long Press (press and release after one beep):
• In RATE mode, it will reset the currently displayed rate if the user has permission (per-
mission set from Lumic 2.0 software). The minimum display will be shown before re-
turning to the count/activity rate.
• In MAX mode, it will reset the current MAX value.
• In COUNT mode, it will:
–
If COUNT mode is ready: It will initiate the count.
–
If COUNT mode is in progress: It will stop the current count and reinitialize the
instrument to begin the next count.
–
If COUNT mode is complete: It will reset the count mode and reinitialize the in-
strument to begin the next count.
Ludlum Measurements, Inc.
