Lucent Technologies OneVision DEFINITY G3 Fault Management, Руководство по установке и интеграции

Страница: 26 / 65

Integration
14 Issue 1 August 1996
Adding DEFINITY G3 PBX Nodes
This section includes the procedures for adding a DEFINITY G3 PBX to the
node map. These procedures are meant to enhance, not replace, your
NMS’s normal instructions for adding a node.
NOTE:
AutoDiscovery, which normally identifies elements of the network and
places them correctly on the network map, does not locate a
DEFINITY PBX or accurately identify the Proxy Agents. Therefore, you
must add PBXs and Proxy Agents manually to a network map.
Node Limitations
The number of PBX nodes you can have is limited by two capacities,
whichever is the smaller capacity:
■
The number of nodes allowed by the NMS
■
The number of Proxy Agents you have to support connectivity with the
PBXs; each Proxy Agent can support up to fifteen DEFINITY PBXs
Adding a PBX as a Managed Node
When you add a PBX as a managed node on the network, you can follow
your NMS's standard procedures. The following steps briefly describe
those procedures and include information specific to adding a DEFINITY
G3 PBX as a node.
To add a PBX as a node, you must complete the following procedures:
■
Add a PBX icon to the network map
■
Configure each PBX object
Adding a PBX Icon
Use the following steps to add an icon to the network map: