LSIS SV004iC5-1F, Руководство пользователя

Страница: 3 / 81

Important User Information
iii
Environment
Surrounding
temperature
-10 ~ 50
℃
(non-freezing), Ambient 40°C for
models SV004iC5-1, SV004iC5-1F, SV008iC5-
1, and SV008iC5-1F (UL 508C)
Relative
humidity
90% RH or less (non-condensing)
Storage
temperature
- 20 ~ 65
℃
Location
Protected from corrosive gas, combustible gas,
oil mist or dust
Altitude,
Vibration Max. 1,000m above sea level, Max. 5.9m/sec
2
(0.6G) or less
(2) Wiring

Do not connect a power factor correction capacitor, surge suppressor, or
RFI filter to the output of the inverter.

The connection orientation of the output cables U, V, W to the motor will
affect the direction of rotation of the motor.

Incorrect terminal wiring could result in the equipment damage.

Reversing the polarity (+/-) of the terminals could damage the inverter.

Only authorized personnel familiar with LS inverter should perform wiring
and inspections.

Always install the inverter before wiring. Otherwise, you may get an
electric shock or have bodily injury.
(3) Trial run

Check all parameters prior to operation. Changing parameter values might
be required depending on the load.

Always apply permissible range of voltage to the each terminal as
indicated in this manual. Otherwise, it could lead to inverter damage.
(4) Operation precautions

When the Auto restart function is selected, stay away from the equipment
as a motor will restart suddenly after a fault stop.

The Stop key on the keypad is valid only when the appropriate function
setting has been made. Prepare an emergency stop switch separately.

If a fault reset is made with the reference signal present, a sudden start
will occur. Check that the reference signal is turned off in advance.
Otherwise an accident could occur.

Do not modify or alter anything inside the inverter.

Motor might not be protected by electronic thermal function of inverter.

Do not use a magnetic contactor on the inverter input for frequent
starting/stopping of the inverter.

Use a noise filter to reduce the effect of electromagnetic interference.
Otherwise nearby electronic equipment may be affected.