![background image](http://html1.mh-extra.com/html/lsc/maxim-lp/maxim-lp_operators-manual_1943914080.webp)
Utilites
maXim
MP L(P) XL(P) XXL(P)
Operator Manual V3
Page 74
LSC Lighting Systems (Aust) Pty. Ltd
has been received at the processor and it is
operating correctly.
To exit;
HOLD
[
function
], tap [
ok
].
23.7.3 FADER
TEST
Enter diagnostics mode (above) then press red
bank [
f/a
] (2).
To test a fader, press the [
f/a
] button for that fader
then move the fader. The display reads from 0 to
255 as the fader is moved through its range. To
select the IN fader, or OUT fader, use the [
<
] and
[
<
] buttons (respectively) above the Stack master.
To exit;
HOLD
[
function
], tap [
ok
].
23.7.4 EDIT WHEEL TEST
Enter diagnostics mode (above) then press red
bank [
f/a
] (3).
Rotate the
EDIT
wheel to test it. The display
should smoothly count up or down as the wheel is
rotated. To exit;
HOLD
[
function
], tap [
ok
].
23.7.5 USB
TEST
Using a USB A to USB B cable, connect the cable
from the Capture connector (USB B).to the top
USB A connector.
Enter diagnostics mode (above) then press red
bank [
f/a
] (6).
The
maXim
will test both directions of
communication between the connectors and
report the condition.
Remove the plug from the top USB connector and
place it in the bottom USB connector then press
red bank [
f/a
] (7).
The
maXim
will test both directions of
communication between the connectors and
report the condition.
To finish press; [
ok
]
23.7.6 BATTERY
TEST
Enter diagnostics mode (above) then press red
bank [
f/a
] (5).
The display will show the battery voltage.
It should be between
approximately
5.8 and 6.4
volts. Press [
ok
].
The display will show the state of the battery as
either, charging or charged.
To exit, press [
ok
].
23.7.7 SYSTEM
ERROR
INFORMATION
Enter diagnostics mode (above) then press red
bank [
f/a
] (10).
The window pops up on the video screen show
showing any system error information. In the
event of any problems, this information can be
conveyed to LSC to assist in fixing problems.
To exit, press [
ok
].
23.7.8 MEMORY
TEST
Enter diagnostics mode (above) then press red
bank [
f/a
] (12).
The display shows the percentage of memory
used. Press [
ok
].
The display will show the percentage of heap
used. (Technical maintenance use only).
Press [
ok
].
The display will show the memory capacity fitted to
the
maXim
.
To exit, press [
ok
].
To exit diagnostics mode press [
no
].
Содержание maXim LP
Страница 2: ......
Страница 3: ...This page intentionally left blank...