(2) Checking Transmission oil
Stop the tractor on level surface and apply the
Parking brake and lower implements to the
ground.
Clean around oil filling inlet and pull the gauge
straight out.
If oil level is between “Max” and “Min” of oil
gauge, it means ‘Proper amount’.
For oil specification, refer to “Lubricants and
Capacity” at the end of this section.
(See page 5-5)
▶
The contaminated oil may reduce the durability of transmission and cause the
<Oil gauge >
Max.
Min.
Oil filling
Inlet and
Oil gauge
▶
The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling inlet and then open the cap.
Caution
(3) Checking Front axle oil
Open the plug of oil check port and make sure to
check if the oil flows out.
If necessary, add new oil into the oil filling inlet.
(after 5~10 minutes later, check the oil level again)
For oil specification, refer to “Lubricants and
Capacity” at the end of this section.
(
See page 5-5
)
Oil check port
Oil filling inlet
(4) Battery check
Refer to “Batter handling and Notices”
(See page 5-29 )
5
5
5
5
- 17
(5) Air cleaner (Dry type)
(See page 5-11)
(6) Cleaning of Radiator and Radiator screen
(See page 5-12)
