5 - 26
Radiator screen
Knob
②
Standard air pressure
- See
chapter 4-4-(6), “Tires and Load capacity” in this manual.
(8) Tire air pressure and damage
①
Check
Check the tire air pressure and damage of the
tires on a daily basis. Always manage the correct
pressure of the front/rear tires, and if the tires are
damaged, change them with new one.
Ensure the tire air pressures are not lower than
the designated values, to prevent;
- blown tires;
- bead wear;
- internal damage;
- irregular wear and short service life.
Do not over-inflate the tires, as this may cause to damage in the event of impact and, in extreme
conditions, the rim and disk may be deformed or the tires may burst.
▶
The dust and dirt, other debris, and damaged fins can cause that cooling efficiency
of the radiator is reduced and the engine can be overheated.
▶
Clean the radiator only after stopping engine.
▶
If cleaning with water, take care not to spray water to the electric and electronic
parts. If possible, DO NOT USE WATER.
Caution
Inspect the radiator and radiator screen for these
items on a daily basis: Damaged fins, corrosion,
dirt, grease, insects, leaves, oil, and other debris.
Clean the radiator and radiator screen, if
necessary.
To access the radiator and radiator screen,
remove the knob(s) and pull out the radiator
screen.
When cleaning the radiator with water, let the
water flow from the fan side.
When cleaning the radiator, check and clean the
other heat exchangers (if fitted) around it.
(7) Cleaning of Radiator and Radiator screen
▶
Do not assemble/disassemble the tires arbitrarily. Only qualified service personnel
should perform this maintenance in a tire repair center equipped with special tools.
▶
When checking tire air pressure, keep the body away from the valve mechanism
or cap. Tire air pressure vary depending on the load weighing on the axles.
Caution
Low
Good
Exceed
Содержание MT345E
