5
CHARGING
When power is applied to the NiMH battery, the charge indicator light on the front
of the battery shows the charge status. The status light indications are:
Continuous Light .......... Fast Charge
Slow Flashing Light ...... Slow Charge
Fast Flashing Light ....... Battery is Fully Charged
Charge the battery until the light shows it is fully charged, then run the GPS
receiver off of the battery until it shuts off. If this lasts only a short time, repeat the
process. This conditions the battery and optimizes its performance.
Remember, you can use the GPS receiver while the battery is charging, although
the GPS receiver doesn't have to be turned on in order to charge the battery.
Using the GPS receiver marginally increase the battery's charge time.
If you remove the battery from the GPS receiver, make certain to slide the bat-
tery cover onto the battery.
SPECIFICATIONS
The battery's input voltage should not exceed 28 volts DC, nor be lower than 12
volts DC.
For best performance, charge the battery at room temperature. Store the battery
at room temperature, also.
Operating temperature:
Discharge ............... -4°F to +122°F
Charge ................... +32°F to +113°F
Содержание AirMap 300
