SOMMAIRE
E 7
4.6) Communication configuration
This rubric is only visible if the unit is equipped with the /CMTCP or /CM option.
COMMUNICATION CONFIG? Push the
(yes) button to access to the rubric.
4.6.1) CMTCP option
IP ADDRESS?
Push the
(yes) button to access to the rubric.
IP1, IP2, IP3, IP4
Use the
/
buttons to increase/decrease the value and the
button to validate it.
The address is decomposed as follow: IP1.IP2.IP3.IP4
The output factory IP address is: 192.168.0.253
IP MASK?
Push the
(yes) button to access to the rubric.
IP1, IP2, IP3, IP4
Use the
/
buttons to increase/decrease the value and the
button to validate it.
The address is decomposed as follow: IP1.IP2.IP3.IP4
The output factory mask is: 255.255.255.0
GATEWAY?
Push the
(yes) button to access to the rubric.
IP1, IP2, IP3, IP4
Use the
/
buttons to increase/decrease the value and the
button to validate it.
The Gateway address is decomposed as follow: IP1.IP2.IP3.IP4
At factory output, the gateway is inactive and equal to: 0.0.0.0
Remark:
- When you access the communication rubric, the device will display at the end of configuration the message 'MeMo' on
the unit display and a series of five lines on the measurement display.
4.6.2) CM option
ADDRESS?
Push the
(yes) button to access to the rubric.
Use the
/
buttons to increase/decrease the value and the
button to validate it.
The output factory address is: 1
BAUD RATE?
Push the
(yes) button to access to the rubric.
Use the
/
buttons to increase/decrease the value and the
button to validate it.
The value available are : 38.4 kbds, 19.2 kbds, 9.6 kbds, 4.8 kbds, 2.4 kbds, 1.2kbds
The output factory baud rate is: 38.4kbds
PARITY?
Push the
(yes) button to access to the rubric.
NONE?
Push the
button to validate the parity none choice. Push
to display the next choice.
EVEN?
Choose of parity even.
ODD?
Choose of parity odd.
4.7) Display configuration
This section allows you to customize the display of measurements on front.
DISPLAY CONFIG?
Push the
(yes) button to access to the rubric.
DISPLAY FILTER?
Push the
(yes) button to access the display filter setting (0 to 60 s).
Allows filtering of the displayed value to smooth fluctuations of the measurement.
DECIMAL POINT?
Push the
(yes) button to access the decimal point mode setting.
AUTO(Y/N)?
Pressing
(yes) selects the automatic decimal point display mode.
Pressing
(no) selects the fixed mode.
NUMBER OF DECIMAL FOR: Choosing the number of decimals (0, 1 or 2) for each measure in fixed display mode.
VOLTAGE?
Push the
(yes) button to access the number of decimals displayed for the voltage measure.
CURRENT?
And so on for all the other measurements.
FREQUENCY?
ACTIVE P.?
REACTIVE P.?
APPARENT P.?
POWER FACTOR?
