SOMMAIRE
E 5
4.3) Network configuration
The wiring options on the network are:
- Alternative or Continuous.
- Single-phase or balanced three phases with neutral for a alternative network.
It is also necessary to configure:
- The Potential Transformer ratio (PT ratio).
- The Current Transformer ratio (CT ratio) or external current shunt sensibility or the Hall sensor current caliber on a
-Hall
version.
NETWORK CONFIG?
Push the
(yes) button to access to the rubric.
Push the
(no) button to go to the next rubric.
ALTERNATIVE?
Push the
(yes) button to choose AC measure mode or the
(no) button to select
the next choice.
CONTINUOUS?
Push the
(yes) button to choose the DC measure mode or the
(no) button to select
the previous choice.
The single phase/three phases rubric is only accessible on a IPL36 in AC mode.
SINGLE PHASE?
Push the
(yes) button to choose the single phase mode or the
(no) button to select
the next choice.
THREE PHASES?
Push the
(yes) button to choose the three phases mode or the
(no) button to select
the previous choice.
PT RATIO?
Push the
(yes) button to access the PT ration setting (0.001 to 10
6
) or the
(no) button
to go to the next rubric.
CT RATIO?
Push the
(yes) button to access the CT ration setting (0.001 to 10
6
) in internal shunt
or
current input configuration.
SHUNT SENSIBILITY? or to access to the shunt sensibility setting (0.001 A/ mV to 10
6
A/mV) in external shunt current
input configuration.
or on a IPL36(L)-Hall
CURRENT CALIBER? Access to the Hall sensor current caliber setting (1 to 65500 A).
Remarks:
-
At factory output a IPL36(L)-Hall is configured in DC (continuous) mode.
- In CONTINUOUS mode, the device calculate the average value of the signal with the response time set in previous
page. For an AC signal the average value is 0.
Signal with an average value < 0.
Signal with an average value > 0.
4.4) Relays configuration
This rubric is only visible if the device is equipped with 1 or 2 relays (options /R1 or /R2).
Each relay has two operating modes:
- Threshold detection (alarm) or,
- Energy metering (IPL36(-Hall) only).
RELAYS CONFIG?
Push the
(yes) button to access to the rubric.
0 V
+100
-100 V
