H100LonWorksManual
17
3.2.10 User Object Output Variables (COM-31–38)
COM-31–38
Para Status-1–8
This parameter is used to configure the addresses for User Object output variables. For more details, refer to the ‘User
Object’ section of this manual.
3.2.11 User Object Input Variables (COM-51–58)
COM-51–58
Para Control-1–8
This parameter is used to configure the addresses for User Object input variables. For more details, refer to the ‘User
Object’ section of this manual.
3.2.12 Communication Update (COM-94)
After making changes to the parameters related to configuring Drive Objects using the keypad, a communication
update is required to apply the changes. Set COM 94 Comm Update to ‘Yes’ to perform a communication update.
After the update, the Comm Update parameter automatically changes back to ‘No.’
Keypad parameters that require the communication update are listed in the table below.
Codes
Parameters
DRV-03
Acc Time
DRV-04
Dec Time
DRV-18
Base Frequency
DRV-19
Start Frequency
DRV-20
Max Frequency
BAS-11
Pole Number
Note
After commissioning the H100 Lon Works communication module, COM-94 Comm Update must be set to ‘Yes’ to
apply the inverter’s configuration properties configured using the keypad.
