H100LonWorksManual
15
This parameter is used to display the version information about the Lon Works communication module that is
installed in the inverter.
3.2.6 Communication Module LED Status Display– FbusLED (COM-9)
This parameter is used to display the status of the four LEDs (CPU, Error, Service, and COM) of the
communication module on the inverter keypad.
Each bit indication(On or Off) on the keypad display, from right to left, represent the status of the COM, Service,
Error and CPU LED.
An example of COM-09 LED State – 1101
LED
COM
(GREEN)
SERVICE
(GREEN)
ERR
(RED)
CPU
(GREEN)
Status
ON
ON
OFF
ON
Keypad Display
3.2.7 Display the Neuron ID– Opt Parameter1–3(COM-10–12)
COM-10
Opt Parameter1
COM-11
Opt Parameter2
COM-12
Opt Parameter3
These read-only parameters are used to display on the keypad the neuron IDs (a 6Byte data value) stored in the
neuron chip of the communication module. Parameters COM10–12 display the neuron ID information in HEX values,
in the order of upper to lower level information.
The information in the neuron IDs 1–3 may be used when you are installing the network manually without using the
service pin on the Lon Works communication module.
