92
After the bucket is filled with materials, just operate the pilot joystick so as to turn
backwards the bucket until the stopper on the bucket contacts with the lift arm, and then
push the pilot joystick to the middle position. Now the maximum rollback angle is obtained.
Raise the lift arm to a certain height, so as to ensure that the bucket may evade the
material pile when the loader is travelling backwards. Just hold the steering wheel with
your right hand, and pull backwards the gear-shifting lever to the reverse gear position
with your left hand, so as to make the loader travel backwards.
After the loader exits from the material pile, just operate the pilot joystick so as to
lower the lift arm to the position whereby the lower linkage point of the lift arm is about
50cm above the ground.
Handling of materials
Under any of the following circumstances, the self-handling may be carried out:
①
The road is soft, the place is not flattened, and it is impossible to use freight vehicle.
②
The handling distance is no more than 500 meters, and the use of freight vehicle is not
economical.
In the course of handling, remain the lower linkage point of the lift arm at the
articulating position (about 50cm above the ground), and turn backwards the bucket to the
limit position (the stopper on the bucket contacts with the lift arm), so as to ensure that the
handling operation may be carried out safely and smoothly and no material will fall out.
The speed of the loader in the course of handling operation depends on the handling
distance and road conditions. When passing any depression or crowing portion, just
release the accelerator pedal, and, if necessary, intermittently apply the service brake, so
as to slow down the loader, make the loader pass the obstacle slowly, reduce the impact
to the loader and prevent the materials from falling down.
WARNING: Do not lift up the bucket to a relatively high position for carrying out the
handling operation, otherwise the loader may overturn.
Unloading of materials
①
Discharging of materials into truck or hopper
When the loader which is loaded with materials is 15 meters away from the truck or
hopper, just release the accelerator pedal, and if necessary, intermittently apply the
service brake, so as to slow down the loader and make the loader approaches the truck or
hopper at a low speed. At the same time, pull the pilot joystick backwards to the limit
position until the control handle is caught up by electromagnet, and then release the
control handle (the handle will not return to the middle position automatically). The lift arm
will rise continuously until it reaches the limit height, and then the electromagnet will be
de-energized, the pilot joystick will automatically return to the middle position, and the lift
arm will not rise any more. In this course, the driver shall carefully drive the loader,
carefully observe the approach by the bucket to the truck or hopper, and may not make
