89
flood.
Apply the service brake to stop the loader.
Pull the gear-shifting lever to the neutral position.
Rotate the hand brake button to reset it and apply the parking braking.
Operate the pilot joystick so as to lower the lift arm, place the bucket horizontal on the
ground and make the bucket press against the ground slightly.
Make the engine run at idle speed for 5 minutes, so that all parts may cool down
evenly.
Turn the electric lock’s key anticlockwise to OFF position to disconnect the control
circuit. Engine stops. Pull out the key.
Set each switch at middle position or off position.
Close the left and right doors, and then go down the stairs in accordance with the
relevant provisions.
If the loader is to be parked for long time (for example, all the night), just open the side
door of the hood and pull the negative pole switch of battery to the off position, so as
to turn off the power supply.
If no anti-freezing fluid is added in the coolant before the loader leaves the factory, just
open all water drain valves of the engine after parking the loader in winter, discharge
all coolant from the cooling system and the evaporator in A/C system, so as to prevent
any part from being frozen and damaged. If the anti-freezing fluid is added when the
loader leaves the factory, please operate as indicated in the nameplate on the rear
end of the loader.
Lock up all equipment, pull out the key and take it with you.
NOTE: Be sure to park the loader on a flat ground. If it is necessary to park the
loader on a slope, be sure to block up the wheels with chocks, so as to prevent the
loader from moving.
If the loader is to be stored for long time, please operate in accordance with the
following requirements:
1. Before Storage
1) Clean up each part of the loader, dry the loader up and then store it in a dry
warehouse. If the loader can only be stored outdoors, be sure to park it on a concrete
ground where water may drain easily, and cover it with canvas.
2) Before storing the loader, fill the fuel tank with fuel, apply grease to each moving pin,
moving shaft and transmission shaft, and replace the hydraulic oil.
3) Pull the gear-shifting lever to the neutral position.
4) Rotate the parking brake button to reset it and apply the parking braking.
