87
2. Step down the service brake pedal, put down
the handle brake button to reset it, slowly let
go of the service brake pedal, and observe
whether the loader moves.
WARNING: If the loader moves, immediately step down the service brake pedal,
rotate the hand brake button to reset it and apply the braking. Thereafter, inspect
whether there is any fault with the gear-shifting control system. If the loader is on a
slope, be sure to block up all wheels with chocks so as to prevent the loader from
moving, and then operate the loader.
3
. Push the control handle so as to get the
forward gear 1 engaged or pull the
gear-shifting lever backwards so as to get the
reverse gear 1 engaged, and at the same
time push down the accelerator pedal
appropriately. In this way, the loader will travel
forwards or backwards.
4. Inspect the engagement of each gear. Drive
the loader to a flat and open ground, get each
gear engaged respectively, and inspect the
gear-shifting operation. If in the operation of
the previous phase, the inspection on
steering performance was not carried out
owing to the small place, please turn the
steering wheel now, and inspect whether the
loader can turn left or right.
NOTE: When carrying out gear-shifting operation, release the accelerator pedal
firstly and then operate the gear-shifting lever for realizing the gear shifting, so as
to protect the gear-shifting clutch.
5. Inspect the performance of service brake. On a flat and open ground, drive the loader
with forward gear 1 or forward gear 2 engaged, release the accelerator pedal, and at
the same time smoothly push down brake pedal. The loader shall slow down
obviously and then stop.
NOTE: If you cannot feel that the loader slows down obviously after the brake pedal
is stepped down, please immediately rotate the red button of parking brake so as to
reset it and apply the emergency braking. At the same time, by operating the pilot
joystick, lower the lift arm to the lowest position, tilt forwards the bucket, and insert
the bucket teeth into or push against the ground, so as to stop the loader and
ensure the safety.
