126
install seat of with non-fiber cloth.
3. Dismount the transparent drainage cup from the lower part of the fuel pre-filter.
4. Clean up the water drain cup, and replace new seal ring, and then install it into a new
fuel filter element of the fuel pre-filter.
5. Fill the fuel into the pre-filter, replace new seals, and smear a layer of engine oil over
the engine, and then install it to the install seat.
5.8.5 MAINTENANCE OF ENGINE OIL
Inspect the oil level of engine oil
1. Park the loader to even field, turn off engine
and rotate the parking brake button to reset.
2. After engine turns off, 10 minutes later, so
that the oil in the engine crankcase to flow
back into the engine oil pan.
3. Open the hood, the engine oil level and
refueling port are all at the right side of the in the
engine.
4. Unscrew and pull out the oil level meter, clean
the oil level meter with a clean cloth, re-insert it
into the engine oil level port till the end, then pull
out to inspect the oil level again, the oil level
should be located between the "L" scale and " H "
of the scale.
5. If the oil level is below the "L" scale, please add
oil; if the oil level is above the "H" scale, please
loosen the release screw piston at the bottom of
the oil pan to release some oil.
Too much engine oil and too little engine will all apt to damage the engine.
5.8.6 REPLACEMENT OF ENGINE OIL
1. When getting up to the required oil change cycle, it requests to replace the engine oil.
Park the machine on the flat playground, and start the engine till the water
temperature reaches to 60
℃
, the engine turns off. Rotate the parking brake button to
reset. Remove the oil outlet screw piston at the bottom of the engine, drain out the oil
with a container to receive the oil, and replace the oil filter.
Warning
