Logosol Multifunctional Servo Drive LS-231g2SB
Doc # 712231006 / Rev. B, 12/26/2017
Logosol, Inc.
•
•
•
•
2833 Junction Ave., Ste. 101
•
•
•
•
San Jose, CA 95134
•
•
•
•
Tel: (408) 744-0974
•
•
•
•
www.logosolinc.com
25
LOGOSOL LS-231g2SB QUICK START GUIDE
Operating in LDCN mode
-
Set DIP-switches 4, 5 and 6 depending on encoder interface you use;
-
Connect power supply to LS-231g2SB;
-
Connect your motor, encoder, hall sensors, and any other I/O you may have;
-
Connect USB or RS-232 adapter and RJ-45 network cable between LS-231g2SB and your host
computer.
Software installation
-
Download and install Logosol Distributed Control Network Utility from:
http://www.logosolinc.com/software/2-logosoldistributedcontrolnetworkldcn.html
Initial Connection to the Host
-
Turn on the power supply;
-
Start
Logosol Distributed Control Network Utility
;
-
Choose the proper COM port;
-
Click
Reset network
button;
-
Load the motor file from
Motor panel / Load Motor settings
. Load motor settings or complete
Motor
Initialization
procedure if you do not have the motor setting for the motor you use;
-
Click
SERVO
button and enter the target position in
Motion Commands / Position
;
Click
GO
button. The motor should rotate slowly toward the target position. Click
Stop
to interrupt
the motion. More information about using LDCN utility is available in LDCN Help.
