12A
-
15
FUEL MIXTURE
Inlet manifold
K7J, and 710
12A
Remove the inlet manifold mounting bolts from brac-
ket (9).
Unclip the inlet manifold electrical harness (10).
Remove the inlet manifold upper mounting bolts
(11).
Remove lower mounting nuts (12) from the inlet ma-
nifold (from below).
Remove the inlet manifold.
REFITTING
Always replace all seals that have been removed.
Refit the inlet manifold, starting with the centre lower
mounting nut (13).
Torque tighten:
- the inlet manifold mounting bolts (2.5 daNm),
- the inlet manifold mounting nuts (2.5 daNm).
Proceed in the reverse order to removal.
107486
107777
Note:
In order to completely remove the bottom centre
mounting nut:
- remove the outer nuts,
- remove the manifold from the cylinder head.
9
12
12
11
11
10
12
12
107777
WARNING
Connect the battery, starting with the positive ter-
minal; carry out the necessary programming (see
80A, Battery, Battery: Removal - Refitting).
13
Содержание X90
