LOGAIRE FIRES MAUI, Инструкция по установке и эксплуатации

Страница: 39 / 52

P:\Public\Spec Sheets\MAUI Gas Fire Indtructions.pdf 39
MAUI ZERO CLEARANCE
ZERO CLEARANCE VERTICAL DIRECT VENT GAS FLUE KIT
INSTALLATION INSTRUCTIONS
This flue kit has been manufactured in accordance with NZS 5261:1996. To ensure
safety this flue kit must be installed as outlined in these instructions. Heater and flue
clearances from combustible walls must be in accordance with heater manufacturers
specifications and NZS 5261:1996.
Referring to diagram 21.
1 Locate heater in its proposed position and mark the
points for penetration that are directly above the centre
of the heater’s flue outlet. Check that the heater’s
location allows the OUTER HEAT SHIELD to clear all
structural timbers.
2 Cut 175mm square holes where penetration is required
to accommodate OUTER HEAT SHIELD
3 Fit timber nogs around holes where necessary.
4 Assemble OUTER HEAT SHIELD sections together
ensuring seams are in line and secure with 3 rivets or
self-tapping screws. Lower OUTER HEAT SHIELD
through roof or chimney structure and fit to heater
spigot. Check height the OUTER HEAT SHIELD
penetrates roof or chimney structure. When calculating
roof penetration height allow for an extra 300mm that
can be achieved by using 3 pop revets or screws and
seal.
5 Fix an appropriate flashing around the OUTER HEAT
SHIELD to seal onto the roofing or chimney material.
6 Assemble the 100mm stainless steel FLUE PIPES
together ensuring all seams are in line using 3 pop rivets
or screws and seal.
7 Lower stainless steel FLUE PIPES from the roof into
the OUTER HEAT SHIELD (crimpled ends towards
the heater) and into the heater flue outlet.
8 Fit FLUE SPACER BRACKETS to FLUE if necessary
to maintain air gap between FLUE PIPES and OUTER
HEAT SHIELD.
DIAGRAM 21