LOGAIRE FIRES MAUI, Инструкция по установке и эксплуатации

Страница: 10 / 52

P:\Public\Spec Sheets\MAUI Gas Fire Indtructions.pdf 10
OPERATION
INITIAL BURNING
The first fire in your stove is part of the paint curing process. To ensure that the paint
is properly cured, light the unit and leave it on for 5 minutes and let it cool down for
30 minutes. Repeat 3 or 4 times. When first operated, the unit will release an odour
caused by the paint curing, the burning off of any oils remaining from manufacturing
and burning off the starch in the gas logs. Also the brick panels will discolour during
the initial burn and return to their original colour after about one hour. This is due to
the burning off of manufacturing starches.
The glass panel may require cleaning after the unit has cooled down.
DO NOT
ATTEMPT TO CLEAN THE GLASS WHILE IT IS HOT.
HEAT OUTPUT ADJUSTMENT
The gas control valve, located behind the lower right access door, can be used to
adjust the heat output and flame height by turning the metal gas knob clockwise for
maximum and counter clockwise for minimum. (see diagram 1 page 8). The
minimum and maximum settings are factory set to provide a wide range of heat output
and should not be altered.
AUTOMATIC CONVECTION AIR FAN OPERATION
The fan control is located behind the lower left access door and is an “HIGH – OFF –
LOW” control. (see diagram 1 on page 8). The fan operates automatically when the
control is in the High or Low position. The fan will turn on as the stove comes up to
temperature. After the unit has been turned off and the stove has cooled to below a
useful heat output range the fan will shut off automatically.
SHUTDOWN PROCEDURE
1. Use the “ON-OFF” rocker switch to turn off the main burner.
2. To turn off pilot light, push in the gas control knob slightly and turn clockwise
to “OFF”. Do not force.
3. Turn off all electrical power to the appliance if service is to be performed.