Loepfe Savio FRS 3000, Инструкция по установке

Страница: 20 / 30

20
3N1
SYSTEM SETUP
*Software : Vm.nn Build yymmdd
i. This is the software version of the user interface
ii. It consists of a major and a minor version number
iii. There is also a build number
iv.

check if this version corresponds to what is required. If not, upgrade with USB stick or change CF card
with correct version (see chapter SCU Software Upgrade)
*IO : Axxxxxx Vm.nn
i. This is the part number and the software version for the I / O controller
*DU : xxxxxx_Vm.nn _$HHHH-LLLL
i. This is the part number, the version and the checksum for the H and L part of the flash
ii. These flashes also contain the software for the SE and the SH
*DU-QB : xxxxxx_Vm.nn _$ssss
i. This is the part number, the version and the checksum for the SE software, that is contained in the DU
flashes
*DU-SENS : xxxxxx_vm.nn _$hhhh
i. This is the part number, the version and the checksum for the SH software, that is contained in the DU
flashes
*SE (X–Y) : xxxxxx_Vm.nn $ssss-bbbb yyyyyy_vm.nn _$hhhh 12345678
i. SE (X–Y): shows the start and end positions for which the data that follows are the same
ii. xxxxxx_Vm.nn: This is the part number and the version of the SE software that was reported by the SE pro-
cessors, that process the data of positions X to Y
iii. $ssss-bbbb : ssss is the checksum of the software; bbbb is the checksum of the bootblock
iv. yyyyyyvm.nn: This is the part number and the version of the SH software that was reported by the sensing
heads, which acquire the data of positions 1 to 8 of each SE processor
v. $hhhh : hhhh is the checksum of the software
vi. 12345678 : indicates the positions for which the previous is valid. “?” means that the SH of that positions
reports another checksum. “-“ means that there is no response from that SH
vii. For instance: 1?3-5678 means that SH 2 of this SE has a different checksum and SH 4 is not found or not
responding
System Test
The start up check is described step by step as follows:
1. Carry out a download of the SE – Software. (see chap-
ter Software for SE)
Caution:
During download, do not interrupt power!
2. Check all software versions. See SCU service/versions.
The following should now be displayed (depending on
machine model other software versions are possible):