4
SAFETY AND HAZARD
Do not operate your Yacht Router and/or add-on modules:
•
In areas where blasting is in progress.
•
Where explosive atmospheres may be present including refuelling points, fuel depots, and chemical plants.
•
Near medical equipment, life support equipment, or any equipment which may be susceptible to any form of radio interference.
In such areas, Yacht Router and add-on modules
MUST BE POWERED OFF
. Otherwise, they can transmit signals that could interfere with this equipment.
In an aircraft, the Yacht Router and add-on modules
MUST BE POWERED OFF
. Otherwise, the Yacht Router and add-on modules can transmit signals that could interfere with various on-
board systems and may be dangerous to the operation of the aircraft or disrupt the cellular network. Use of cellular and WIFI equipment in an aircraft is illegal in some jurisdictions. Failure
to observe this instruction may lead to suspension or denial of cellular services to the offender, or legal action or both.
IMPORTANT:
It is solely on end-user to set transmitting power value for WIFI Booster to comply with regulations of country where product will be used. Regulations and online WIFI power
calculators (EIRP - Equivalent Isotropically Radiated Power) are widely available on the Internet. Locomarine Networks d.o.o. cannot by responsible by any means for improper setup.
Transmitting power is set and regulated via Yacht Router Control software.
IMPORTANT: Exposure to Radio Frequency Radiation.
63 cm minimum distance has to be maintained between the antenna and the occupational user and 142 cm to general public. Under such configuration, the FCC radiation exposure limits
set forth for an population/uncontrolled environment can be satisfied.
List of approved antennas:
Omni Directional (pole), model Locomarine MOB 7
ANTENNA INSTALLATION:
antennas from other products MUST NOT BE CO-LOCATED within 20 cm range to each other to satisfy FCC regulations.
WARNING:
It is installer’s responsibility to ensure that when using the authorized antennas in the United States (or where FCC rules apply); only those antennas certified with the product
are used. The use of any antenna other than those certified with the product is expressly forbidden in accordance to FCC rules CFR47 part 15.204. The installer should configure the output
power level of antennas, according to country regulations and per antenna type. Professional installation is required of equipment with connectors to ensure compliance with health and
safety issues.
PREFACE
Содержание NMEA0183 TO ETHERNET CONVERTER
Страница 21: ...21 www yachtrouter com ...