LNS QUICK LOAD SERVO S3 T BARFEED, Руководство по обслуживанию

Страница: 27 / 152

PROCEDURES
SERVICE MANUAL – QL Servo S3-T
MAGAZINE AND LOADING FINGER ADJUSTMENT
The slope of the magazine rack needs to be adjusted when the shape of the material being loaded changes from round to
profiled or visa versa.
When loading round stock, if the slope of the magazine is too much it is possible for the material to stack up and cause double
loading if the weight of the material is great enough (especially when loading smaller diameter stock). Therefore, the slope
must be reduced.
When loading profiled (ex. square/hex) stock, if the slope of the magazine is not great enough it can prohibit the ability of the
material to slide down the rack. Therefore, the slope must be increased.
INFORMATION
The following conditions must be met to complete this procedure:
• No stock on the magazine
• Bar feed in STOP mode
PROCEDURE [ROUND] -> [PROFILED]
Rotate the loader rack adjustment axle CCW to increase the slope of the magazine until the indicator on
the side of the magazine references the profiled material.
Note
: if there is not enough adjustment on the threaded rod, remove the pin and lift the magazine up to
the next hole and reinsert the pin. Caution when removing the pin, the magazine rack will drop if not
supported properly.
PROCEDURE [PROFILED] -> [ROUND]
Rotate the loader rack adjustment axle CW to decrease the slope of the magazine until the indicator on
the side of the magazine references the round material.
Note :
if there is not enough adjustment on the threaded rod, remove the pin and drop the magazine
down to the next hole and reinsert the pin. Caution when removing the pin, the magazine rack will drop if
not supported properly.