LNS QUICK LOAD SERVO S3 T BARFEED, Руководство по обслуживанию

Страница: 77 / 152

SETTINGS
SERVICE MANUAL – QL Servo S3-T
SERVICE
NFORMATION
T he service parameters allow to configure the bar feed system in its
environment and to adapt the interface connected to the lathe. Changing
these values can damage the devices and create operator safety issues.
Therefore, these parameters are protected with a password, and only an
LNS (or certified) technician is authorized to modify them
1. Bar feeder 1. Bar feeder location
(left hand / right hand)
2. Unit
(mm/inch)
3. Time for clamping device to close
(factory value 0.0 sec)
4. Time for clamping device to open (factory value 0.0 sec)
2. Position 1. Distance behind the clamping system
(mm)
2. Safety distance
(factory value 10 mm)
3. Limit position for the loading pusher (mm)
4. Max. bar length
(mm)
5. Front limiter position
(mm)
6. Measuring probe position (mm)
7. Loading pusher length
(mm)
3.
Speed/Torque
1. Speed before bar measurement
(min/max factory values 80 - 400 rpm)
2. Loading cycle speed (min/max factory values 100 -3000 rpm)
3. Speed without bar
(min/max factory values 1000 - 4000 rpm)
4. Bar feed rate
(min/max factory values 100 - 3000 rpm)
5. Speed at front in manual mode
(min/max factory values 100 - 1000 rpm)
6. Speed at rear in manual mode (min/max factory values 100 - 2000 rpm)
7. Torque without bar
(min/max factory values 0 - 100%)
8. Torque during bar loading
(min/max factory values 2 - 80%)
9. Torque during part loading (min/max factory values 2 - 80%)
4. Options 1. Bar feeder with guide for profiled bars (no/yes)
2. Bar feed with telescopic pusher (no/yes)
5. Interface
(standard
parameters)
These parameters set the communication and working mode between the lathe and the barfeed.