11
Gebruiks- en montagehandleiding inbouwbranders/ Operating and assembly instructions built in burners / manuel de montage et mode d'emploi
-
Improper installation, adjustments or modifications to the equipment can result in injury or property
damage. Read the installation instructions, safety precautions and operating instructions very
carefully.
-
Do not leave the Livin’ flame built in burner unattended when it is in use or when it is connected to a
gas cylinder.
-
What to do if the device emits a smell of gas : Turn off the bottle immediately and directly contact a
technical specialist gas . Do not use the device until the device is approved for use again
-
Installation, maintenance and service needs to be done by qualified gas fitter in this cases.
-
Only use the Livin’ flame built in burner outdoor or in a well-ventilated area. Never use the built in
burner inside a building , house , garage or any other enclosed area .
-
Gas bottles must be placed outdoors and stored in well-ventilated areas. Make sure that gas bottles
are out of the reach of children. Gas bottles which are used or disconnected from the Livin’ flame built
in burner may not be stored in a building, garage or any other enclosed area .
-
The Livin’ flame built in burner is best stored in a garage or well-ventilated area . Store the Livin’ flame
built in burner only when it is disconnected from the gas bottle.
-
The Livin’ flame built in burner is not qualified as a cooking appliance and must not be used as a
cooking appliance.
-
Check at least every month and every time a change is made to the unit if the Livin’ flame built in
burner has no gas leaks .
-
Keep the area around the Livin’ flame built in burner clear of combustible liquids, materials and vapors
. Never throw anything in the heat of the Livin’ flame built in burner.
-
Never use a fuel other than propane gas.
Turning on the Livin’ flame built in burner
- Make sure the Livin’ flame built in burner is stable and in solid state.
- Remove the protection cover.
- Press the ignitor fully until you hear a slight ticking sound (this is the piezo ignition). If you
hear nothing when pressing the ignition button, then you probably need to replace the battery. Hold
the control knob pushed in when you open the gas supply. Turn the control knob to the right for gas
supply. The burner should now ignite within 15 seconds . If the burner gives a completely flame, you
hold the control knob for 15 seconds withheld . The flame continues to burn. Extinguishes the flame,
try this again and hold the button longer retained .
Switching off the Livin’ flame built in burner
- Turn the control knob to the left so that the flame goes out. If the flame is out you turn off the gas
valve on the gas bottle.
- Let the lava rocks and eventual ceramic logs cool down completely and place the SS cover on the
built in burner
4. Specifications: built in burner
Livin’ flame built in burner
Type of gas and associated gas
Butane / Propane I3+ 28-30
mbar (NL, L U)
Propaan I3P-37 mbar
(BE, LU, GB, FR, AT)
I3P - 50 mbar (DE, AT, CH)
Heating capacity:
8,5 kW / 8,5 kW / 11,5 kW
Injector:
1.5 mm
Gas consumption:
600 gr / 600 gr / 837 gr / h
