Pre-Cut Value Gable Shed/Value Workshop Shed
ASSemBly InStruCtIOn mAnuAl
2
Assembly Instruction manual
© 2020 Little Cottage Co.
*PleASe nOte: A 10’X14’ WOrKSHOP SHeD WAS uSeD FOr PICtureS SHOWn - yOur lAyOut mAy VAry*
5.
Set OSB sheeting in place, using the speed square,
make sure the OSB is flush with the 2x4 on both sides.
6.
Secure the OSB sheeting in place by fastening it with
2” nails to the 2x4’s every 6-8 inches.
1.
thank you for purchasing from little Cottage Co.!
If you have any questions during construction please
call us at 330-893-4212. You will find all the components
necessary to build your storage shed. Refer to your buy
list for specific contents which will vary by unit.
2.
Using the floor diagram layout sheet, locate your rim
and floor joist and lay them out.
Note: A 10x14 workshop shed was used for the pictures
shown, your layout may vary.
3
. Start at the corner and use the square to make sure
the corner is flush and fasten with 3” nails.
4.
Next square up the floor. To square the floor, use a tape
measure to find the distance from one corner to the other, then
measure the diagonal between the remaining 2 corners. If the
two measurements are the same, then your floor is already
squared. If they aren’t, adjust the floor until the measurements
are the same.
