Lissmac SBM-L 1000 G1S2 ALU MIX, Руководство по эксплуатации

Страница: 60 / 82

Changing abrasives
Grinding Machine SBM-L 1000+1500 G1S2 ALU MIX 60
6.2.8 Measuring wear
After replacing an abrasive belt, always adjust the S-unit so that the wear
display is on "Zero".
If the upper and lower wear measuring device is on zero, a normal edge
rounding should be achieved.
If a heavy edge rounding is desired, a deviation can also be made.
Abb. 56: Mechanical wear display
1 Wear display on bottom S-unit
2 Hand lever to apply display of lower wear measurement
3 Wear display on top S-unit
4 Lever for wear display
5 Base plate for upper abrasive belt
6 Base plate for lower abrasive belt
Both abrasive belts can be measured independently of one another.
Measuring the wear on the upper abrasive belt

To measure the upper abrasive belts, lift the lever (4) out of its interlock
and pull it back.

Place the base plate (5) onto the abrasive belt.

Read the wear on the wear display (3).

Bring the base plate (5) back into initial position.
Measuring the wear on the lower abrasive belt

To measure the lower abrasive belts, left the lever (2) out of its interlock
and move it downwards until the base plate (6) is on the abrasive belt.

Read the wear on the wear display (1).

Bring the base plate (6) back into initial position.