Lissmac SBM-L 1000 G1S2 ALU MIX, Руководство по эксплуатации

Страница: 55 / 82

Changing abrasives
Grinding Machine SBM-L 1000+1500 G1S2 ALU MIX 55
6.2 Replacing S-unit abrasive belt
6.2.1 Preparing to replace the abrasive belt
The abrasive belts on the S-unit differ according to the material to be
processed.
The abrasive belts have opposite operating directions in both the upper and
the lower S-unit.
The existing wear must be reset to reuse the abrasive belts. To do this, note
the wear (1) and (2) shown in the display and later apply the value to the
abrasive belt.
Since the abrasive belts depend on the operating direction, the direction of
the abrasive belts must also be logged.
NOTE
To prevent damage to the abrasive belts, the S unit (upper or lower), the
running direction and the wear of the abrasive belts must be recorded.
6.2.2 Recording wear
Abb. 49: Wear display (display in operation mode 5.3.1)
1 Wear display of upper S unit
2 Wear display of lower S unit

Note "Wear" display on the respective abrasive belt.
1
2