Lissmac COMPACTCUT 905 P/T, Руководство по эксплуатации

Страница: 27 / 80

27/80
Sequence
 Retain the blade guard at the top with the chain and the hook (pos.1)
 Remove the screw at the pressure disc with the tool kit and take out the pressure disc

Take off the old saw blade (ATTENTION: the blade is very hot after cutting!)

Insert spacers as required (observe the clamping range)
 Place a suitable diamond tool on the shaft (observe the size and direction of rotation)

Align the hole pattern of the saw blade on driving pins

Mount the pressure disc with the screw and tighten

Loosen the blade guard from the chain loosen and lower in a controlled manner
Depth stop
If the cutting shaft cannot is lowered too far, the exposed belt touches the ground surface and is damaged
or destroyed. To avoid this, the saw arm travel must be limited by setting the end stop.
Calibration of the hood
This set screw enables the adjustment of the
relative height and position of the blade guard to
the cutting surface if necessary.
1
1
2