Lissmac COMPACTCUT 905 P/T, Руководство по эксплуатации

Страница: 16 / 80

16/80
2.4.4. Maneuvering the floor saw
Maneuvering of the floor saw may only be carried out when the saw blade is standing still.
Before leaving the operating position at the floor saw, the engine must be stopped and the saw blade
must stand still.
Danger of injury exists through a rotating saw blade.
The operator may not leave the floor saw, as long as the parking brake has not been operated. Any
rolling away must be prevented.
2.4.5. Special work in the context of the use of the machine
Observe the setting, maintenance and inspection activities and - dates including specifications for the
exchange of parts/partial equipment prescribed in this operating manual. These activities may only be
carried out by authorized technical personnel.
Inform the operating personnel before starting the execution of special and maintenance work! Name a
supervisor!
If the floor saw is switched off during maintenance and repair work, it must be secured against
unexpected restarting.
Before cleaning, all openings must be covered and sealed, into which no cleaning agent may penetrate
for safety and functional reasons. Electric motors, switches and plug connections are especially
endangered. The covers/seals must be removed completely after cleaning.
Always tighten loose screw connections during maintenance and repair work.
Any safety devices removed during the preparation, maintenance and repair has to be reinstalled
immediately after conclusion of the maintenance and repair work.
Rotary tools, whose maximum speed is smaller than the nominal speed of the machine may not be
used.
2.5. Note on special types of danger
2.5.1. Dangers for the operator through the machine
Before leaving the operating position at the floor saw, the engine must be turned off and the saw blade
must stand still. There is a cut hazard form rotating saw blade.
Work on the floor saw as well as the maneuvering with rotating saw blade are prohibited.
The engine of the floor saw may only be operated for the intended use:
Drive of the floor saw / the saw blade.
The outlet opening of the exhaust pipe must always point away from the operator. Do not inhale
exhaust gases.
The exhaust system gest hot during operation. Avoid contact and wear protective equipment.