Lipco UFD 100, Перевод оригинальной инструкции

Страница: 20 / 24

Original instructions Reversing Harrow UFD 100/110/120/140
20 - 24 100102-02-EN BA UFD 100_110_120_140 / 09.08.2019
14. Replacement of the cutting blades
When replacing the cutting blades, make sure that the machine is
secured against unintentional tilting! When working with the unit
lifted, always secure the unit mechanically by means of adequate
supporting elements! Turn off the engine and pull the ignition key!
When replacing them, it is very important to maintain the cutting
blade arrangement, especially the direction of the cutting edge. The
blades must always be mounted in cutting direction. (Note: When
replacing cutting blades, it is recommended replacing the screws and
nuts as well! Always use the original screws with fine pitch thread!)
15. Storage after use
If the
LIPCO Reversing Harrow UFD is to remain unused for a longer
period, it is necessary to carry out the following steps:
•
Thoroughly wash and dry the LIPCO Reversing Harrow !
•
Thoroughly check the function of the moving parts, replace any
damaged, worn or deteriorated parts!
•
Check whether all screws are tightened!
•
Check the oil and lubricant levels!
•
Clean and lubricate the universal joint shaft!
•
Grease all unpainted metal parts to protect them against
corrosion, cover the LIPCO Reversing Harrow and store it in a
dry place so that it will be ready for use any time.
•
Attention!
Before using the unit again, follow the instructions in
chapter "13. Maintenance".