Explo Trainer
User’s Manual
Version 1.1 | 18/06/19
Page 18
Frequently asked questions
This section deals with the most common malfunctions and/or errors and possible solutions. If you
have any doubts, please feel free to contact LION Fire Training Products.
Problem:
Possible solution:
The Student Unit is not detecting anything from
the transmitters
Check whether all the transmitters set out are
switched on. Check whether all the power LEDs
on the transmitters are flashing. If the LED is not
flashing but the device is switched on, the
transmitter’s battery power is probably too low.
Charge the transmitter and try again. If the
problem persists, contact the manufacturer.
The Instructor Unit cannot detect the Student
Unit, although both devices are switched on.
The Instructor Unit is not showing the measured
values on the Student Unit.
Check whether both devices are set to the same
channel.
Check whether both batteries are sufficiently
charged, and check whether both devices are
within range. For the purposes of this test, hold
them less then two meters apart. Switch off both
devices and then switch on the Instructor Unit
first, followed by the Student Unit. If the problem
persists, contact manufacturer.
Either the Instructor Unit or the Student Unit is
not responding to the button being pressed, or
one of the units is showing strange symbols on
the display.
Connect the device to the battery charger for at
least five minutes, then disconnect it and switch
the device back on.
When switching on the Instructor or Student Unit,
it shows the LION logo, but then immediately
switches itself off
The battery is completely empty and the device
switches itself off in order to prevent battery
damage. Recharge the unit completely using the
battery charger and try again. If the problem
persists, contact manufacturer.
