Explo Trainer
User’s Manual
Version 1.1 | 18/06/19
Page 11
Setting Alarm values A1
-
Press and hold the mode button (6) for at least 2 seconds.
The display will show “Set A1” and the values
are the alarm levels for the preset lowest
alarm levels. When one of the measured values
(or manually adjusted values in measuring mode)
exceeds the preset values in this menu,
both the Student Unit and the Instructor Unit
will generate a slow alarm. See figure 3.12.
-
Select the desired measurement by pressing the mode button (6) shortly
After each press, the arrow will move to the next measurement.
-
Use the up (7) and down (8) buttons to adjust the level of the selected measurement to the desired
level.
The range of the alarm levels is the same as for adjusting values manually.
-
Press the mode button (6) shortly to select the next measurement.
Or
-
Press the power button (4) shortly to go back to measuring mode.
Setting Alarm values A2
-
Press and hold the mode button (6) for at least 2 seconds.
The device will show the Alarm values A1 menu.
-
Press and hold the mode button (6) again for at least 2 seconds.
The display will now show “Set A2” and the values
are the alarm levels for the preset highest
alarm levels. When one of the measured values
(or manually adjusted values in measuring mode)
exceeds the preset values in this menu,
both the Student Unit and the Instructor Unit
will generate a fast alarm. See figure 3.13.
-
Select the desired measurement by pressing the mode button (6) shortly
After each press, the arrow will move to the next measurement.
-
Use the up (7) and down (8) buttons to adjust the level of the selected measurement to the desired
level.
The range of the alarm levels is the same as for adjusting values manually.
-
Press the mode button (6) shortly to select the next measurement.
Or
-
Press the power button (4) shortly to go back to measuring mode.
Figure 3.12: Set Alarm values A1
Figure 3.13: Set Alarm Values A2
