Linhai M565Li T3 EFI, Руководство по обслуживанию

Страница: 26 / 338

CHAPTER 2 MAINTENANCE
M565LiT3 EFI SERVICE MANUA 20.0
CHAPTER 2 MAINTENANCE PAGE. 2- 13
1. First check foot brake effectiveness by
applying a 25 kg (50 lb). (Approx)
downward force on
the pedal.
The top of the pedal should be at least 1
inch, (25 .4m m) above the surface of the
footrest.
If less than one inch, two things must be
examined:
Free Play:
Free play of the brake pedal
should be
1/8-1/4 inch (3-6mm).
If free play is excessive, inspect pedal,
linkage, and master cylinder for wear or
damage and replace
any w
orn parts.
Bleeding:
If free play is correct and brake pedal travel is
still excessive, air may be trapped some
where in the system. Bleed the hydraulic
brake system in a conventional manner,
following the procedure outlined in the Brake
chapter.
MECHANICS PARKING BRAKE
FOR
EUROPE ATV
CONTROLS
Check controls for proper operation,
positioning and adjustment.
Note:
burnishing procedure is also applicable
for parking brake. See CHAPTER 7
BRAKES.
FOOT BRAKE TESTING
The foot brake should be checked for
proper adjustment.
Support the rear wheels off the ground. While
turning the rear
wheels by hand, apply the
auxiliary footbrake. This brake should not
stop the wheels from turning until the lever is
half
way be
tween its rest position and
bottoming on the footrest.
Checking
Although the parking brake has been
adjusted at the factory, the brake should be
checked for proper operation. The
mechanical brake must be maintained to be
full functional.
Brake control and switch must be positioned
to allow brake level to travel throughout entire
range without contacting switch body.