Subject to modifications
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Page 21 of 32
User Manual
Operating Instructions
2.1EN-38016-C09
Replace pump element
5 026a96
Fig. 9-3 Replace pump element
Remove the pressure relief valve from the pump element.
Unscrew the
pump element.
IMPORTANT
Take care that the piston, the pull-back
spring and the washer are not left lying in
the grease. If thes e parts remain in the
lubricant, the motor may seize. In the case
of a later removal of the parts, the reserv oir
will have to be disassembled.
6001a02
NOTE
Pump elements with adjustable lubricant
output are to be set to the required output
before ins tallation.
Install a new pump element with a new s ealing ring.
Repair
Pump
Use only original Lincoln spare parts for repair on the
pumps.
The pump should be returned to the factory for warranty
work or major repairs.
Defective printed circuit boards should be suitably packed
and returned to the factory.
Maintenance, Repair and Tests, continuation
Printed Circuit Boards
6001a 02
IMPORTANT
Whenever the pump housing has been
opened (e. g. for replacing of the p.c.b.), the
housing cover (including the foamed seal)
must be replac ed.
Disassemble defective control p.c.b.
Note down the jumper positions of the defective control
p.c .b. To do so, follow instructions given in paragraph
„Jumper Configuration“.
Pack the defective control p.c.b. properly so that it will
reach the factory without any further dam ages.
In the cas e of a replacem ent of the control p.c.b., there will
always be supplied a standard version (V10) of the p.c.b.
Set the jum per configuration on the new control p.c.b.
according to the one noted down from the old control p.c .b.
Connect the new control p.c.b. and install it properly.
