Lighthouse Handheld 3016 IAQ, Руководство по эксплуатации

Страница: 29 / 136

00
5HY 4-1
4
Operation - Particle
Mode
Note:
Operation of the
instrument in Mass
Concentration Mode is
described in the next
chapter.
This chapter describes how to use the HANDHELD 3016 IAQ
Airborne Particle Counter in Particle Mode.
Using the
Instrument
The HANDHELD comes with a charged battery and is ready for use.
To start using the instrument, proceed as follows:
WARNING:
Do not
attempt to sample
reactive gases (such as
hydrogen or oxygen)
with this instrument.
Reactive gases create an
explosion hazard in the
instrument.
Sampling any gas under
pressure can damage the
instrument and void the
warranty.
Sampling any gas that is
not the same density as
ambient air can result in
inaccurate data.
Contact Lighthouse for
more information.
1. Insert the battery included with the shipment (see Chapter 2 for
instructions.)
2. Position the instrument in the environment to be measured.
3. Remove the protective cap from the inlet tube. To use the
provided isokinetic probe, install it by connecting to inlet tube on
the top of the instrument.
NOTE: Do not discard the protective
cap. It should be placed on the inlet tube any time the
instrument is to be moved outside the environment being
measured.
4. The included Temperature/Relative Humidity probe can be
attached to the provided receptacle to read environmental data.
5. Set on/off switch found on the left side of the unit to ON.
6. The Start Up screen displays on the LCD.
7. The MAIN screen appears.
8. On the touch screen, press the START button to start the
instrument.
9. “STARTING” will display when the pump is initially turned on.