E. Maintenance Alarm
Operation Cycles Count Setting
a)
Press and hold
SET
Button until “1” appears on the display, next
press the
UP
button until “E” appears on the display to enter this
function setting then release the button.
b)
Press the
SET
button again. The unit is now in the maintenance
alarm adjustment mode. You will see a figure “0” with a flashing dot
on the display.
c)
Press
UP / Down
button, you can select the operation cycles you
need the operator to make you notice. You can choose from “1-5” set.
Figure “1”:
Once garage door has operated to 1000 times, the LED light will
flash 10 times quickly after the door opens. This is to make you
aware that your garage door needs to be serviced.
At the same time, you will see a figure “t” appears on the display.
Figure “2”:
The maintenance alarm count cycle is set on 2000 times.
Figure “3”:
The maintenance alarm count cycle is set on 3000 times.
Figure “4”:
The maintenance alarm count cycle is set on 4000 times.
Figure “5”:
The maintenance alarm count cycle is set on 5000 times.
d)
Press
SET
button to confirm the set and it will be back to standby
status automatically and display “ll”.
NOTE:
1.
The operation cycles count is set on “0” as default.
2.
“b” appears on display and led light flashes 10 times quickly, the
door has become un-balanced, it is strongly recommend the garage
doors is serviced.
3.
“Check” the status and/ or “Re-learn” the travel limit after
maintenance alarm cautions.
F. Open / Stop / Close Terminals
The O/S/C facility can be used for an external push button switch to operate the operator.
The switch must have voltage free normally open contacts.
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
21
