PROGRAMMING INSTRUCTIONS
Pre- Instruction for programing controller buttons
1.
Short press
SET
button : When in standby, this will clear the error, alarm display, and return to
normal display.
2.
Short press
CODE
button :
(In the Setting Status)
Exit the current operation and return to the standby interface.
When in standby, press the CODE button, A dot will be displayed in the corner.
The system is now entering the code learning mode.
Click the button of the hand transmitter you want to use, the dot may disappear ,then press the same
button again, the dot will flash and the code learning has finished.
3.
Short press
UP
button :
The door will open.
4.
Short press
DOWN
button :
The door will close.
(When the door is opening or closing, it will stop if you press any key.)
5.
Long press
SET
button :
Enter function setting interface.
6.
Long press
CODE
button : Press and hold
CODE
button until a C is indicated on the display.
All stored remotes will be deleted.
7.
Long press
UP
button :
Increase the resilience.
(Keep pressing DOWN button, after 4 seconds, it will
scroll to display 0-1-2, choose the number you want. 1=increase 25% 2=increase 50%)
8.
Long press
DOWN
button :
Restore Factory Settings
Keep press
DOWN
button, after 4 seconds, it will scroll to display , then the garage door
operator will restart.
Restarting the unit will reset all settings back to factory settings, all coding needs to be completed
again, except the transmitter code learning.
11
