PROGRAMMING INSTRUCTIONS
1. Programming Open & Close Limits
a)
Press and hold
SET
button to enter this function setting until “1”
appears on the display then release the button.
b)
Press the
SET
button again. The door operator is now in
Programming Mode. You will then see “n” with a dot appears on the
display.
c)
Press and hold the
UP
button until the door reaches the desired
open position, you will see “n” without dot on the display.
d)
Press
SET
button to confirm the open position, then you will see
“u” with dot on the display.
e)
Next press and hold the
DOWN
button until the door reaches the
desired close position, you will see “u” without dot on the display.
NOTE: For fine adjustments toggle UP & DOWN buttons.
f)
Now press the
SET
button to confirm the close position, then you
will see “II” on the display.
After confirm the close position, the door will now cycle open and
close to set the travel limits and force sensitivity adjustments. The
door is now set for normal operation.
CAUTION: After the open and close cycle, there will be figures
shown on the display (0~9), “0” indicates the doors is balanced,
the smaller the figure, the better the door balance.
It is strongly recommend that this figure is smaller than the
power force.
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
SET
UP
C
ODE
DOWN
12
