Lifetime Sentinel 6414, Руководство пользователя с инструкциями по сборке

Страница: 39 / 44

3
Pegboard Installation
23
Use a Level, and position both 1” Pegboard Strips (BA)
in the desired locations. Screw the Pegboards to the wall
using #10 x 3/” Screws (ML). See Note .
23a
Hardware Bags: 1012088
Screwdriver, Level
Step 23 Hardware
ML (10)
ML
Achoring the Shed
24
24a
After assembling your shed, you may want to anchor it to the ground. It can be anchored through
the Floor Brackets (FA) you attached to each Wall Support. Consult your local hardware store for
suggestions on the best hardware to use for anchoring your shed. Whatever you use, the diameter of any
screw or bolt cannot exceed 3/”.
Adjust Door Spacing
25
25a
You may need to move the tops and/or bottoms of the doors to eliminate uneven gaps. Loosen the Carriage
Bolts at the four corners of the door frame. Loosen all Screws in the left and right Door Hinges by a half a
turn. Move Doors until gaps are even. Re-tighten the four Carriage Bolts. Re-tighten the Screws in the left
and right Door Hinges.
Insert Anchoring Hardware
through the Floor Brackets
(FA) attached to the bottom of
each Wall Support.
FA
Loosen these Carriage
Bolts before adjusting
Doors.
Loosen the Screws
in both Hinges before
adjusting Doors.
The Pegboard Strips are
screwed directly into the
plastic. Line up Strip anywhere
on wall so that holes are over
plastic (and not over a groove in
the wall).
Be sure that the Pegboard Strip is
level before inserting Screws.