12
PawRunner User Manual Lifepro
Endurance Training Collection
13
ATTACH THE CROSSBAR TO THE BASEFRAME
You will need:
crossbar
(C)
, 2 M6×6 screws
(L)
,
2 curved washers
(M)
, hex key
(N)
ATTACH VELCRO
®
STRIPS TO THE CROSSBAR
You will need:
crossbar
(C)
, 2 Velcro
®
strips
(D)
1. Insert the base of the crossbar
(C)
onto the two round inserts on either
side of the treadmill baseframe
(A)
, just behind the motor housing.
2. Place a curved washer
(M)
onto one of the screws
(L)
.
3. Insert the screw/washer combination through the screw holes on the
left side of the crossbar
(C)
and into the baseframe
(A)
.
4. Repeat 3–4 above to attach the right side of the crossbar to the
baseframe.
5. Use the hex key
(N)
to fully tighten each screw.
1. Loop one Velcro
®
strip
(D)
around the left side of the crossbar
(C)
and
one strip around the right side:
• The smooth side of the Velcro
®
strip will face to the
INSIDE
of
the treadmill. The hook and loop side of the Velcro
®
will face to the
OUTSIDE
of the treadmill.
• Loop just enough of the Velcro
®
strip around the crossbar to be
able to close the loop. The rest of the strip will extend straight out
creating a Velcro
®
tab. This tab will be used to attach the fabric side
panels.
• Position the two loops a few inches from the base of the crossbar.
• The loops should be loose enough that they can be repositioned
along the crossbar, if necessary.
C
C
D
A
D
(L)
(M)
x2
x2
TOOLS & HARDWARE
(N)
L
M
3
2
