40
PawRunner User Manual Lifepro
Endurance Training Collection
41
WARNING:
Always power off the treadmill, by flipping the power switch
to the OFF position, and unplug the power cord before starting any
maintenance, cleaning, or repairs.
ADJUSTING THE RUNNING BELT
WARNING:
If the running belt has become so displaced that it is rubbing
along one of the side rails, this will cause friction and defects to the running
belt. Damage caused by failure to adjust the belt or insufficient adjustments
will not be covered by the warranty under any circumstances.
To achieve as long a service life as possible, the running belt should always
be kept running straight along the center of the running deck. Therefore, it
is important to examine the belt before each exercise session to see if it is
straight and running in the center of the deck or if it has changed position.
Possible reasons for the running belt changing position are:
• The ground on which the treadmill is standing is either uneven or at an
incline.
• Your pet’s walking or running style (for example, distribution of weight to
one side).
HOW TO ADJUST THE RUNNING BELT
If the Belt Is Running to the Left of Center:
1. Start the treadmill and set the speed to
1.5–2 mph with no load (no pet on the
treadmill).
2. Use the provided hex key to turn the left
adjustment screw, located at the back end
of the belt, ¼ turn clockwise.
3. Allow the treadmill to run with no load for
1–2 minutes to see if the belt is now running along the center.
4. If the running belt is now running in the center of the running deck, the
adjustment was successful. If the belt is still off-center, repeat steps
1–3 until the belt is running in the center.
If the Belt Is Running to the Right of Center:
1. Start the treadmill and set the speed to
1.5–2 mph with no load (no pet on the
treadmill).
2. Use the provided hex key to turn the right
adjustment screw, located at the back end
of the belt, ¼ turn clockwise.
3. Allow the treadmill to run with no load for
1–2 minutes to see if the belt is now running
along the center.
4. If the running belt is now running in the center of the running deck, the
adjustment was successful. If still off-center, repeat steps 1–3 until
the belt is running in the center.
NOTE:
If the belt cannot be adjusted, please contact a support
representative immediately.
HOW TO FIX A JAMMED RUNNING BELT
If the Belt Is Jammed and Cannot Move:
1. Start the treadmill and set the speed to
1.5–2 mph with no load (no pet on the
treadmill).
2. Use the provided hex key to turn the
left and right adjustment screws ½ turn
clockwise.
3. Allow the treadmill to run with no load for
1–2 minutes to see if the belt is now running along the center.
4. If the running belt is now unjammed, the adjustment was successful. If
the belt is still off-center, repeat steps 1–3 until the belt is running in
the center.
