USE OF DRAIN PIPE
- 7 -
- 8 -
1. The height of the drain pipe should be less than 47 inches, otherwise it will cause poor
drainage. If the draining time is too long, the washing machine will stop midway.
2. DO NOT step on or squeeze the drain pipe.
3. If the drain pipe is too long, it can be cut from the middle part. For smooth drainage,
the front end of the drainage pipe can be cut diagonally.
4. When the drain pipe needs to be lengthened, please purchase another drain pipe.
The inner diameter of the drain pipe is not less than 1.2 inches and the length is not
more than 59 inches.
INSTALL THE WATER INLET PIPE
1. The Quick Connection Adaptor is primarily for quick connection to a single faucet. If the
faucet does not match the water inlet pipe, the quick connection adaptor is required. The
adaptor consists of two parts that quickly connect or disconnect. One part, the faucet
fitting, is for connection to the faucet and the other part, the hose fitting, connects to the
cold water hose of the washer.
- Pull back on the white ring to free the faucet fitting from the adaptor for installation into
the faucet.
- Screw the end of the cold water hose onto the base of the hose fitting.
- If the faucet has internal screw threads, unscrew the aerator if present from the tip of
the faucet. Then screw the faucet fitting into the faucet. Make sure that the black rubber
gasket is on the top of the adaptor before screwing it in.
（
The black rubber gasket is
about 2mm higher the top of the adapter)
- If the faucet has external screw threads, remove the gasket from the top of the faucet
fitting, and screw the fitting over the external threads.
- Pull back on the white ring to connect the two parts of the adaptor back together.
NOTE
: When connected to a single faucet, be sure to run cold water only.
3. Tighten the fittings by hand until they are snug, and then tighten them an additional
two-thirds of a turn with a wrench.
< 59 in
> 1.2 in
< 47 in
