- 9 -
- 10 -
PREPARATION BEFORE WASHING
1. Connect the water inlet pipe and open the faucet valve.
2. Fasten the buttons and pull the zippers.
3. Do not wash too much, jeans and bulky clothes should be loosely placed.
Precaution
• Check whether the clothes are suitable for washing in the washing machine;
• Separate clothes that are easy to fade;
• Please put the clothes that are not easy to absorb water into the water by hand;
• For clothes with more mud and dust, please remove the dirt first, especially the dirty
parts, you can dip detergent in advance, so that it is easier to remove the dirt on the part;
• Turn over and throw in the clothes that are easy to pilling and long pile;
• Do not put clothes contaminated by chemicals directly into the washing machine;
• Please put small items, easy-entangled clothing, worn clothing and plush into a net bag
for washing.
Clean out your pockets
and take out coins,
hairpins, etc.
Fasten the buttons and
pull the zippers.
DO NOT wash too much.
Jeans and bulky clothes
should be loosely placed.
Gound
When you fasten the fittings, do not fasten them too tightly or apply
tape or seal to the faucets or water supply intakes. This can damage
the fittings. After you have connected the water supply hoses to the
faucet, ensure that they are connected securely by pulling the water
supply hoses downwards.
4.
Place the unconnected ends of the hoses into a bucket and open the faucets connected
to the two water supply hoses for 10 or 15 seconds to remove any substances from the
hoses. Close the faucets before continuing.
5. Connect the ends of the water supply to the water supply intake connections at the top
of the washer.
The water hose connected to the COLD faucet must be connected to the cold water
supply intake.
6. Tighten the fittings by hand until they are snug, and then tighten them an additional
two-thirds of a turn with a wrench.
Ensure that the water supply hoses are not twisted or bent. If the hoses are twisted
or bent, the hoses can leak and cause electric shock due to the water leakage. To
ensure the correct water usage, connect to the COLD water faucet.
7. Turn on the COLD water supplies and check all the water supply intake connections
and the faucets for water leaks.
NOTE
: After the connection is completed, if there is water leakage, please connect
again according to the above steps. Please use the water inlet pipe provided by the
manufacturer. The old water inlet pipe cannot be reused and do not use other
self-provided water inlet pipes to avoid water leakage.
